Showing 1–8 of 13 results
We’ve gathered all of the features that you might need in order to make your store online in this theme.
CH340 is a series of USB bus adapters, that provides serial, parallel or IrDA interfaces over the USB bus (note: CH340G supports serial interface only). The CH340G integrate circuit provides common MODEM signals to allow adding a UART to a computer or converting existing UART devices to USB interface. Features:- • Full-speed USB interface, compatible…
The DS75176B is a high speed differential TRI- STATE@bus/line transceiver designed to meet the requirements of EIA standard RS485 with extended common mode range (+12V to —7V), for multipoint data transmission. In addition, it is compatible with RS-422. The driver and receiver outputs feature TRI-STATE capability, for the driver outputs over the entire common mode…
The IR2110 is high voltage, high speed power MOSFET and IGBT driver with independent high and low side referenced output channels. Proprietary HVIC and latch immune CMOS technologies enable ruggedized monolithic construction. Logic inputs are compatible with standard CMOS or LSTTL output, down to 3.3V logic. The output drivers feature a high pulse current buffer…
KA2281 is a linear integrated circuit having 16 pins its 16 dual in line package its a 5 DOT dual led meter driver. It contains 2 LED channel which is basically designed for the use of stereos, Home stereos and tape recorders. Its supply voltage is 16 V, Its capable for driving red, green and…
L293D is a dual H-bridge motor driver integrated circuit (IC).Motor drivers act as current amplifiers since they take a low-current control signal and provide a higher-current signal. This higher current signal is used to drive the motors. L293D contains two inbuilt H-bridge driver circuits. In its common mode of operation, two DC motors can be…
The LM3914 is a monolithic integrated circuit that senses analog voltage levels and drives 10 LEDs, providing a linear analog display. A single pin changes the display from a moving dot to a bar graph. Current drive to the LEDs is regulated and programmable, eliminating the need for resistors. This feature is one that allows…
The LM3915 is a monolithic integrated circuit that senses analog voltage levels and drives ten LEDS, LCDs or vacuum fluorescent displays, providing a logarithmic 3 dB/step analog display. One pin changes the display from a bar graph to a moving dot display. LED current drive is regulated and programmable, eliminating the need for current limiting…
The MAX485 is low-power transceivers for RS-485 and RS422 communication. Each part contains one driver and one receiver. The driver slew rates are not limited, allowing them to transmit up to 2.5Mbps. These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers. Drivers are short-circuit current limited…
We’ve gathered all of the features that you might need in order to make your store online in this theme.
Copyright © 2021 - Venam All Rights Reserved.
